Paxton 360-864SC-US Spezifikationen PDF herunterladen

Ins-30040-US PROXIMITY architectural reader

10/11/2010

Technical Support

Technical help is available: Monday - Friday from 02:00 AM - 8:00 PM (EST)

Saturday from 04:00 AM - 08:00 AM (EST)

1.800.672.PAXT [email protected]

Fitting

The reader insert is held against the backplate by an outer

decorative bezel secured with 4 small screws. Remove these

screws to release the bezel and ret after adding the insert.

If you have made an insert of less than 3/16 inch thick, this

can still be tted by using the 3 nylon screws supplied in the

tting kit to hold the insert against the bezel. (see diagram)

To remove the reader, insert the

tool provided into the cut out

on the underside of the reader.

Push up the clip and pull the

reader from the backbox.

Reader insert

Removing the reader

Ensure that the backbox is mounted vertically and is

square with the wall surface.

Care must be taken when doing this, as no further 'twist'

adjustment is possible within the reader mountings.

Line up the two locating pins on the top of the

reader with the top plate inside the backbox.

Once located, the reader can be clipped into the

box at the bottom using the clip feature.

Check that the reader is located against the

surface of the wall. If there is a gap between

the reader and the wall, or if the reader will

not successfully clip into the box, remove the

reader and adjust the mounting plates inside the

backbox using a 3 mm Allen key.

Mounting the reader

Documentation on all Paxton products can be found on our web site - http://www.paxton-access.com/

Paxton

1 2 3 4

Inhaltsverzeichnis

Seite 1

Ins-30040-US PROXIMITY architectural reader10/11/2010Technical SupportTechnical help is available: Monday - Friday from 02:00 AM - 8:00 PM (EST)

Seite 2 - Connection modules

Cable extensionsReaders can be extended using Belden CR9538 8 core overall screened cable to a maximum of 500 feet.WiringIMPORTANT: This reader canno

Seite 3 - Suitability

1 - Readers/Keypads not working.Q- Software settings - Conrm that the settings of the reader or keypad are correct. Q- Connections - Check the wiring

Seite 4 - FCC Compliance

VoltageClock and data bit period Carrier frequency-20 °C (-4 °F)+55 °C (+131 °F)IPX710V DC 14V DC 140 mA125 kHz600 µs2 3/4” 4 3/8”3/8”2 3/8” 4”1”1

Kommentare zu diesen Handbüchern

Keine Kommentare

Paxton 360-864SC-US Spezifikationen

Stöbern Sie online oder laden Sie Spezifikationen nach Magnetkartenleser Paxton 360-864SC-US herunter. Paxton 360-864BL-US magnetic card reader Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern