Entry conrmation button
Door contact
switch
Door lock LED
indicator
Using an entry conrmation button
Where two door readers may pick up the same hands free token, a push to make button can be used to
conrm an entry request for the specic door. Where tted, the button LED will ash for 5 seconds after the
hands free token has been recognised and must be pressed to unlock the door.
To enable the use of an entry conrmation button do the following steps:
1. Power down the interface board
2. Power up the interface board
3. Press and hold the entry conrmation button for a minumum of 3 seconds within 60 seconds of power up.
To disable the use of the button, repeat the above process.
Enrolling hand free keyfobs and keycards
Switch SW2 is used to select the xed channels used by the two keycard buttons. Select either switch 1 or 2
to set which keycard button the interface will respond to.
The unit must be power cycled if the switch position is changed, to activate the new setting.
Hands free keyfobs
These tokens should be assigned to users as per standard keyfobs. They will then operate with normal P series
readers or via the hand free interface when in range.
Hands free keycards
These should rst be assigned as per the hands free keyfob.
To enable the buttons, the keycard must rst be presented to the P series reader and then used in hands free
mode. The keycard stores the details of this interface and can then activate the door using a button.
It can also be used in normal hands free mode and also in local passive mode with other standard readers.
Kommentare zu diesen Handbüchern