Paxton OEM hands free keycard Bedienungsanleitung PDF herunterladen

Ins-30053 OEM hands free keycard

05/01/2010

Battery replacement

The keycard has been designed with features to extend battery life, these include a two second timeout once

access has been granted and a capability to prevent repeated access to the same door whilst the keyfob remains

in the eld of the reader. Leaving the keycard in the eld of a reader will reduce battery life.

Remove the screw on the back of the card. Open the case by inserting a at head screw driver in the slot at

the bottom of the card and gently prising the case open. Remove the circuit board and replace the batteries.

Replace the circuit board, casing cover, screw and label.

The hands free interface has a pair of switches

labelled SW2. Select either switch 1 or 2 to set

which button the interface will respond to.

Power cycle the interface to store this setting.

Interface Settings

To enable the buttons, the keycard must rst be presented to the P series reader and then used in hands free

mode. The keycard stores the details of this interface and can then activate the door using a button.

It can also be used in normal hands free mode and also in local passive mode with other standard readers.

The keycard can store up to 14 doors, seven for each button.

Data Reset

To clear the stored gate information from the keycard hold down both buttons for 3 seconds.

The system comprises of a hands free interface, a compatible reader (see specication table) and hands free

keycards or keyfobs. The system operates by using the eld being transmitted by the P series reader to wake up

the token. This then communicates with the interface which contains a long range receiver.

The keycard increases this effective read range to typically 5 m (maximum 50 m). This is achieved by activating

the system manually instead of using the reader eld.

OEM keycards also include a standard EM4100 proximity ID chip and can therefore be presented to any compatible

proximity reader whether they are using the hands free interface or not.

What is hands free?

Suitability

Compatible with hands free readers

Compatible with non hands free readers

SW2

Hands free interface

Switch settings

1 2 3 4

Inhaltsverzeichnis

Seite 1 - Switch settings

Ins-30053 OEM hands free keycard05/01/2010Battery replacementThe keycard has been designed with features to extend battery life, these include a two s

Seite 2 - Specications

85 mm54 mm 9 mmEM4100 125 kHz 2.4 GHz0 °C 50 °C1 x CR2430P38 850 mmP50 1100mmP75 1500 mmP200 2500 mm2000 mm5000 mmSpecications Carrier frequency Ope

Seite 3

Ins-30053 OEM hands free keycardBattery replacementThe keycard has been designed with features to extend battery life, these include a two second time

Seite 4

85 mm54 mm 9 mmEM4100 125 kHz 2.4 GHz0 °C 50 °C1 x CR2430P38 850 mmP50 1100mmP75 1500 mmP200 2500 mm2000 mm5000 mmSpecications Carrier frequency Ope

Kommentare zu diesen Handbüchern

Keine Kommentare

Paxton OEM hands free keycard Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Für Zuhause Paxton OEM hands free keycard herunter. Paxton OEM hands free keycard User Manual Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Für Zuhause Paxton OEM hands free keycard